Konica Minolta Bizhub C220 C280 C360 Error Code C3421 reset

Konica Minolta bizhub C220, C280, C360 error code reset

There is some information that may help you solve this fixing Error code C3421 problem. Here in this post, I explain how to fix Error Code in Konica Minolta C220, C280, C360 series, which should solve your problems. This introduction will help you troubleshoot some common fixing error messages related to Error Code c3421, c3423, c3721, c3722, c3723, c3821 that you may receive. We are sharing a few methods to fix the error, so check them one by one until it gets solved.

The maintenance sign means that The copier needs to be well serviced and checked if something is to be replaced. Consumables such as drum, blade, fuser rollers, and developer are changed at such times. If you are sure that you have replaced the correct part or nothing is to be replaced, then you can proceed to clear the sign.

Meaning of the Error Code?

The fixing error (c3421, c3423, c3721, c3722, c3723, c3821) code refers to a copier warm-up error; the machine had not reached the correct temp within a specific time. The Fusing Roller Thermistor does not detect the required temperature within 30 sec. after a warm-up cycle has begun; therefore, the copier does not complete the warm-up cycle.

How to fix the error code?

If 1st time occurs, you need to go into service and clear the error then reset. Easy to reset and fault usually goes away.

Follow these steps to fix you a problem:

• Reset error code: Turn the main switch off using the switch inside the front door, (not the one on the control panel). Then Whilst holding the UTILITY key button on the panel switch the machine back on hold the utility button down until TROUBLE RESET appears on the touchscreen then touch this, OK will be displayed then power the machine off and wait at least 10 seconds then back on. After it checks if the machine starts correctly.

If fixing error code c3451 appears again then check these all things.

Some of the possible causes:

• Check the fusing unit for the correct installation (whether it is secured in position).
• Check the open/close operation of the right door.
• Check the fusing unit, DCPU and PRCB for proper connection and correct or change as necessary.
• Change the fusing unit.
• Change PRCB.
• Change DCPU.

If you find your parts, then replace the parts and error still remains, after resetting the error code. If the error is still showing even after the above solutions, then you have no choice other than calling the Konica Minolta technician.